Civil 3D

[geosilva]

Salutare,

Stie cineva daca si cum se pot face in Civil 3D 2011 profile transversale intre doua suprafete ridicate in plan ?
Mai exact ma intereseaza, in cazul constructiei unui drum, sa fac profile transversale, in mod automat la pozitiile din picheti, iar suprafeta de referinta sa fie ridicarea topo initiala la care sa ma raportez cu ridicarea topo a statului de asfalt, in diferite stadii de executie.

Multumiri.

[doru2]

To superimpose a profile-singura metoda rapida, dar insemna sa ai cate un profil in loc de profil transversal pentru fiecare in parte.

poti incerca sa te uiti in corridors pentru restul(link corridors) dar nu ma intreba prea multe, e doar o sugestie.


Identify the source profile you want to superimpose. Ensure that each profile appears in a profile view.
Click Home tab   Create Design panel   Profile drop-down   Create Superimposed Profile .At the Command prompt, enter SuperimposeProfile.
In the drawing, click the source profile line.
Click the grid of the destination profile view.
Optionally, on the Limits tab, specify a limited range of stations to superimpose.
NoteIf you want the superimposed profile station range to remain fixed, then select the Select Start and Select End checkboxes and the superimposed profile will not react to changes in the station range of the source alignment. If the Select Start and Select End boxes are not selected, then the start and end of the superimposed profile locks to the start and end of the source alignment. If the start or end of the source alignment changes, the superimposed profile updates dynamically.
Optionally, on the Accuracy tab, specify different mid-ordinate distances for curve tessellation.
Click OK.